This DTC is stored when the combination meter assembly detects a fuel sender gauge malfunction via a direct line.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1500 | When IG voltage is 9.5 V or more and the following condition is detected:
1.
Fuel sender gauge operation malfunction |
·
Harness or connector ·
Fuel sender gauge assembly ·
Combination meter assembly |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Fuel Input | Fuel input/Min.: 0 L, Max.: 127.5 L | 10th segment illuminated: 31.7 to 36.0 | Unit: Liter |
| 9th segment illuminated: 28.5 to 31.7 | |||
| 8th segment illuminated: 25.4 to 28.5 | |||
| 7th segment illuminated: 22.1 to 25.4 | |||
| 6th segment illuminated: 19.2 to 22.1 | |||
| 5th segment illuminated: 16.2 to 19.2 | |||
| 4th segment illuminated: 12.7 to 16.2 | |||
| 3rd segment illuminated: 9.8 to 12.7 | |||
| 2nd segment illuminated: 6.9 to 9.8 | |||
| 1st segment illuminated: 4.5 to 6.9 |
| Result | Proceed to |
|---|---|
| Fuel level data can be displayed on the intelligent tester and DTC B1500 is output. | A |
| Fuel level data cannot be displayed on the intelligent tester. | B |
A
B
Disconnect the M22 fuel sender gauge assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G1-2 (L) - M22-2 (FS) | Always | Below 1 Ω |
| G1-2 (L) - Body ground | Always | 10 kΩ or higher |
| M22-3 (FE) - Body ground | Always | Below 1 Ω |
OK
NG
Remove the fuel sender gauge assembly (See page Engine / Hybrid System>1NZ-FXE FUEL>FUEL SENDER GAUGE ASSEMBLY>REMOVAL).
Check that the float moves smoothly between E and F.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Float level is F (upper) | 13.5 to 16.5 Ω |
| 1 - 2 | Float level is between F (upper) and E (lower) | 13.5 to 414.5 Ω (Gradually changes) |
| 1 - 2 | Float level is E (lower) | 405.5 to 414.5 Ω |
| *a | Front view of wire harness connector
(to Fuel Sender Gauge Assembly) |
OK
NG
Visually check for deformation on the fuel suction tube assembly with pump and gauge connector.
There is no deformation.
OK
NG