Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM › 2014.12–2017.06
RM2170E _58 Vehicle Interior _057039 SUPPLEMENTAL RESTRAINT SYSTEMS _0278099 AIRBAG SYSTEM D

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  SYSTEM DESCRIPTION  


GENERAL


a.

Deceleration sensors used for the airbag system are installed to various parts on the vehicle and calculate the deceleration rate of each part during a collision.


b.

Depending on the situation, the airbag sensor assembly sends a deployment signal to each airbag and pretensioner based on the information from each sensor.



DEPLOYMENT CONDITION


a.

FRONTAL COLLISION

C245662E15
0.354,1.656 1.917,2.167 1.563,0.51 10 false Airbag Sensor Assembly 0.438,2.969 1.865,3.229 1.427,0.26 10 false Front Airbag Sensors 2.635,2.333 2.99,2.719 0.354,0.385 10 false AND 4.177,0.563 6.823,0.917 2.646,0.354 10 false Horn Button Assembly (Driver Side Squib) 4.021,1.208 6.865,1.875 2.844,0.667 10 false Instrument Panel Passenger Airbag Assembly (Front Passenger Side Squib) 3.979,2.094 6.885,2.635 2.906,0.542 10 false Lower No. 1 Instrument Panel Airbag Assembly (Driver Side Knee Airbag Squib) 4.24,2.979 6.635,3.448 2.396,0.469 10 false Curtain Shield Airbag Assembly LH/RH (Curtain Shield Squib LH/RH) 4.271,3.875 6.708,4.469 2.438,0.594 10 false Front Seat Outer Belt Assembly LH/RH (Front Pretensioner Squib LH/RH)

i.

Frontal collision signals are produced based on the information from the airbag sensor assembly and front airbag sensors.

HINT:

In the case of a frontal collision, the SRS ignition signal may be output after receiving an ON signal from the deceleration sensor built into the airbag sensor assembly even without a signal from the front airbag sensors.



ii.

Frontal collision signals are used to deploy the SRS parts in the diagram.



b.

SIDE COLLISION (Pattern 1)

C241767E10
5.021,0.438 6.802,1.146 1.781,0.708 10 false Front Seat Airbag Assembly (Side Squib) 4.896,1.667 6.906,2.25 2.01,0.583 10 false Curtain Shield Airbag Assembly (Curtain Shield Squib) 0.406,0.594 2.281,0.969 1.875,0.375 10 false Side Airbag Sensor Assembly 0.563,1.917 2.146,2.396 1.583,0.479 10 false Airbag Sensor Assembly 3.531,1.292 3.948,1.792 0.417,0.5 10 false AND

i.

Side collision (Pattern 1) signals are produced based on the information from the airbag sensor assembly and side airbag sensor assembly.


ii.

Side collision (Pattern 1) signals are used to deploy the SRS parts in the diagram.



c.

SIDE COLLISION (Pattern 2)

C240621E09
4.875,1.073 6.875,1.427 2,0.354 10 false Curtain Shield Airbag Assembly (Curtain Shield Squib) 0.188,0.479 2.438,0.677 2.25,0.198 10 false Side No. 2 Airbag Sensor Assembly 0.49,2.021 2.042,2.229 1.552,0.208 10 false Airbag Sensor Assembly 3.49,1.24 3.802,1.427 0.313,0.188 10 false AND

i.

Side collision (Pattern 2) signals are produced based on the information from the airbag sensor assembly and side No. 2 airbag sensor assembly.


ii.

Side collision (Pattern 2) signals are used to deploy the SRS part in the diagram.