Be sure to correctly follow the removal and installation procedures for the curtain shield airbag assemblies.
62180A
1.INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (for Vehicle not Involved in Collision)
Perform a diagnostic system check (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).
Visually check for defects with the curtain shield airbag assemblies installed on the vehicle.
The defects are as follows:
Cuts on each pillar garnish or the roof headlining assembly around the curtain shield airbag assemblies
Small cracks on each pillar garnish or the roof headlining assembly around the curtain shield airbag assemblies
Significant discoloration on each pillar garnish or the roof headlining assembly around the curtain shield airbag assemblies
No defects are found.
If any of the defects is found, replace each pillar garnish or the roof headlining with a new one.
62180A
2.INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)
Perform a diagnostic system check (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).
Visually check for defects with the curtain shield airbag assemblies removed from the vehicle.
The defects are as follows:
Cuts
Small cracks
Significant discoloration
Cracks or other damage to the connector
No defects are found.
If any of the defects is found, replace the curtain shield airbag assembly with a new one.