71075B
1.INSTALL BENCH TYPE REAR SEAT CUSHION COVER
Temporarily install the bench type rear seat cushion cover to the bench type rear seat cushion pad.
Using hog ring pliers, install the bench type rear seat cushion cover to the bench type rear seat cushion pad with 16 new hog rings.
Be careful not to damage the bench type rear seat cushion cover.
Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the bench type rear seat cushion cover.
Using hog ring pliers, install 38 new hog rings.
Be careful not to damage the bench type rear seat cushion cover.
Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the bench type rear seat cushion cover.
72640A
2.INSTALL REAR SEATBACK LOCK ASSEMBLY LH
Install the rear seatback lock assembly LH with the 2 bolts.
72630C
3.INSTALL REAR SEATBACK LOCK ASSEMBLY RH
Install the rear seatback lock assembly RH with the 2 bolts.
71077B
4.INSTALL BENCH TYPE REAR SEATBACK COVER
Temporarily install the bench type rear seatback cover to the bench type rear seatback pad.
Using hog ring pliers, install the bench type rear seatback cover to the bench type rear seatback pad with 4 new hog rings.
Be careful not to damage the bench type rear seatback cover.
Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the bench type rear seatback cover.
5.INSTALL BENCH TYPE REAR SEATBACK COVER WITH PAD
Temporarily install the bench type rear seatback cover with pad to the rear seatback frame sub-assembly.
for Center:
Engage the 4 claws to install the 2 rear center seat headrest supports to the rear seatback frame sub-assembly.
for LH Side:
Engage the 4 claws to install the 2 rear seat headrest supports to the rear seatback frame sub-assembly.
for RH Side:
Engage the 4 claws to install the 2 rear seat headrest supports to the rear seatback frame sub-assembly.
Close the 2 fasteners as shown in the illustration.
Engage the 2 hooks.
Engage the hook as shown in the illustration.
72646A
6.INSTALL REAR SEATBACK STOP BUTTON GROMMET
Engage the 2 claws to install the rear seatback stop button grommet to the bench type rear seatback cover with pad.
Use the same procedure for the RH side and the LH side.
72661C
7.INSTALL REAR SEATBACK LOCK RELEASE BUTTON
Turn the rear seatback lock release button in the direction indicated by arrow to install it.
Use the same procedure for the RH side and the LH side.