Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM (w/o Occupant Classification System)
RM2170E _58 Vehicle Interior _057041 SEAT BELT _0278116 SEAT BELT WARNING SYSTEM U

SEAT BELT  SEAT BELT WARNING SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Combination Meter or Main Body / Data List.


e.

Read the Data List according to the display on the intelligent tester.

Combination Meter
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
P-Seatbelt Buckle SW Front passenger seat belt buckle switch signal/ON or OFF ON: Front passenger seat belt unfastened
OFF: Front passenger seat belt fastened
Front passenger seat occupied
Driver Side Seatbelt Warning Buzzer Driver seat belt warning buzzer/ON or OFF Customized value displayed -
P-Seatbelt Warning Buzzer Front passenger seat belt warning buzzer/ON or OFF Customized value displayed -

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
D Seat Buckle SW Driver seat belt buckle switch signal/ON or OFF ON: Driver seat belt fastened
OFF: Driver seat belt unfastened
-



ACTIVE TEST


Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Combination Meter / Active Test.


e.

Perform the Active Test according to the display on the intelligent tester.

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Driver Side Seat Belt Seat belt warning light OFF / ON -