73360
1.INSPECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY
Before installing the rear seat 3 point outer belt assembly, check the ELR function.
Do not disassemble the retractor.
When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.
| *1 | Retractor |
| *a | Unlocked |
| *b | Locked |
| *c | 45° |
If the result is not as specified, replace the rear seat 3 point outer belt assembly.