73350
1.INSPECT REAR SEAT LAP TYPE CENTER BELT ASSEMBLY
Before installing the rear seat lap type center belt assembly, check the ELR function.
Do not disassemble the retractor.
When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.
| *1 | Retractor |
| *a | Unlocked |
| *b | Locked |
| *c | 45° |
If the result is not as specified, replace the rear seat lap type center belt assembly.