If the driver door glass or the power window regulator motor assembly (for driver door) does not operate smoothly, the jam protection function may be triggered automatically, resulting in the auto up function being unable to fully close the window.
If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).
If a power window regulator motor assembly and door window regulator sub-assembly have been removed and installed, or if a power window regulator motor assembly was reused when a door glass or door glass run was replaced, initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).
Initialize the power window regulator motor assembly (for driver door) (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).
NEXT
Check that the driver door power window moves when the auto up and down functions of the power window regulator master switch assembly are operated (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).
Driver door power window auto up and down function is normal.
OK
NG
Remove the window regulator.
Install the window glass onto the door glass run.
Check if the door window regulator operates smoothly.
Check that the window glass slides smoothly when sliding it up by hand.
Door window glass slides smoothly.
Ensure the following:
The window glass fits with the glass run without improper contact or deformation.
Foreign objects are not caught in the glass run.
Perform initialization again.
OK
NG