The jam protection function operates within a specified range during the manual up or auto up operation.
If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).
Initialize the power window regulator motor assembly (for driver door) (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).
NEXT
Check if the power window auto up and down function operate normally (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).
Driver door auto up and down function is normal.
OK
NG
Check if the jam protection function operates normally for the driver door power window.
The jam protection function will not operate within 4 mm (0.157 in.) of the fully closed position.
Jam protection function operates normally.
OK
NG