Home › Vehicle Exterior › WINDOW / GLASS › WINDOW DEFOGGER SYSTEM
RM2170E _59 Vehicle Exterior _057045 WINDOW / GLASS _0278152 WINDOW DEFOGGER SYSTEM U

WINDOW / GLASS  WINDOW DEFOGGER SYSTEM  TERMINALS OF ECU  


CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY


U159194E03
3.406,0.281 3.729,0.448 0.323,0.167 10 false G34

a.

Disconnect the G34 air conditioning amplifier assembly connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

HINT:

Measure the values on the wire harness side with the connector disconnected.


Tester Connection Wiring Color Terminal Description Condition Specified Condition
G34-1 (IG+) - G34-14 (GND) V - W-B Ignition power supply Power switch on (IG) 11 to 14 V
G34-1 (IG+) - G34-14 (GND) V - W-B Ignition power supply Power switch off Below 1 V
G34-14 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω
G34-21 (B) - G34-14 (GND) BE - W-B Auxiliary battery power supply Power switch off 11 to 14 V

If the result is not as specified, there may be a malfunction on the wire harness side.



c.

Reconnect the G34 air conditioning amplifier assembly connector.


d.

Measure the voltage according to the value(s) in the table below.

Tester Connection Wiring Color Terminal Description Condition Specified Condition
G34-37 (LIN1) - G34-14 (GND) LG - W-B LIN communication signal Power switch on (IG) Pulse generation
G34-38 (RDFG) - G34-14 (GND) B - W-B Rear window defogger signal Power switch on (IG), rear window defogger switch OFF 11 to 14 V
G34-38 (RDFG) - G34-14 (GND) B - W-B Rear window defogger signal Power switch on (IG), rear window defogger switch ON Below 1 V

If the result is not as specified, the air conditioning amplifier assembly may have a malfunction.




CHECK AIR CONDITIONING PANEL (HEATER CONTROL SWITCH BOARD)


U159670E03
3.406,0.281 3.99,0.542 0.583,0.26 10 false G33

a.

Disconnect the G33 air conditioning panel (heater control switch board) connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

HINT:

Measure the values on the wire harness side with the connector disconnected.


Tester Connection Wiring Color Terminal Description Condition Specified Condition
G33-5 (IG+) - G33-8 (GND) V - W-B Ignition power supply Power switch on (IG) 11 to 14 V
G33-5 (IG+) - G33-8 (GND) V - W-B Ignition power supply Power switch off Below 1 V
G33-8 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction on the wire harness side.



c.

Reconnect the G33 air conditioning panel (heater control switch board) connector.


d.

Measure the voltage according to the value(s) in the table below.

Tester Connection Wiring Color Terminal Description Condition Specified Condition
G33-2 (LIN1) - G33-8 (GND) LG - W-B LIN communication signal Power switch on (IG) Pulse generation

If the result is not as specified, the air conditioning panel (heater control switch board) may have a malfunction.