53630
1.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)
Pass the hood lock control cable assembly into the engine compartment.
Pass the cable through the upper radiator support.
Engage the hood lock control cable assembly to the 3 clamps and grommet to connect the hood lock control cable assembly.
53630
2.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)
Pass the hood lock control cable assembly into the engine compartment.
Pass the cable through the upper radiator support.
Engage the hood lock control cable assembly to the 3 clamps and grommet to connect the hood lock control cable assembly.
53601
3.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Connect the hood lock control cable assembly to the hood lock control lever sub-assembly.
Engage the 3 claws to install the hood lock control lever sub-assembly.
53510
4.INSTALL HOOD LOCK ASSEMBLY
Apply MP grease to the sliding areas of the hood lock assembly.
Connect the hood lock control cable.
Install the hood lock with the 3 bolts.
62112
5.INSTALL COWL SIDE TRIM BOARD LH (for LHD)
67914
6.INSTALL FRONT DOOR SCUFF PLATE LH (for LHD)
62111C
7.INSTALL COWL SIDE TRIM BOARD RH (for RHD)
Use the same procedure for the RH side and LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION).
67913
8.INSTALL FRONT DOOR SCUFF PLATE RH (for RHD)
Use the same procedure for the RH side and LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION).
53301
9.INSPECT HOOD SUB-ASSEMBLY
53301
10.ADJUST HOOD SUB-ASSEMBLY
53876A
11.INSTALL FRONT FENDER LINER LH (for LHD)
Use the same procedure for the RH side and LH side (See page Vehicle Exterior>WIPER / WASHER>WASHER MOTOR(for Front Side)>INSTALLATION)
12.INSTALL FRONT WHEEL LH (for LHD)
53875A
13.INSTALL FRONT FENDER LINER RH (for RHD)
14.INSTALL FRONT WHEEL RH (for RHD)