Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR SUPPORT
RM2170E _59 Vehicle Exterior _057046 DOOR / HATCH _0278163 BACK DOOR SUPPORT A

DOOR / HATCH  BACK DOOR SUPPORT  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 68961 1.INSTALL BACK DOOR STAY BOLT

a.

Clean the threaded portion on the vehicle body with a non-residue solvent.


b.

Clean the threaded portion on the vehicle body with a non-residue solvent.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



c.

Install the back door stay bolt.

Torque:
22 N*m (224 kgf*cm, 16 ft.*lbf)


Hide 68945 2.INSTALL BACK DOOR DAMPER STAY UPPER BRACKET

a.

Clean the threaded portion on the vehicle body with a non-residue solvent.


b.

Apply adhesive to the threads of the 2 bolts.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



c.

Install the back door upper damper stay bracket with the 2 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 68960B 3.INSTALL BACK DOOR STAY ASSEMBLY

NOTICE:
·

Avoid touching the stroke portions of the rod as much as possible to prevent foreign matter from attaching to the stroke portions. Be sure to hold the cylinders while servicing.

·

Do not wear cotton gloves or other similar materials when handling the rod. Fibers may attach to the rod and result in gas leaks.

·

Do not apply any load to the cylinders in the horizontal direction, in order to prevent the rod from being deformed.



a.

When reusing the back door stay assembly:

i.
B299127

Install the 2 stop rings to the back door stay assembly.



b.
B297015

Install the back door stay assembly.

NOTICE:

Install the back door stay assembly while supporting the back door by hand.



c.

Check that the back door stay assembly is engaged in the ball joint and that the back door stay assembly cannot be pulled out.