84840G
1.INSPECT BACK DOOR OPENER SWITCH ASSEMBLY
Check the operation of the opener switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 2 (E) - 3 (UL) | Back door opener switch not pushed | 10 kΩ or higher |
| 2 (E) - 3 (UL) | Back door opener switch pushed | Below 1 Ω |
| *a | Component without harness connected
(Back Door Opener Switch Assembly) |
If the result is not specified, replace the back door opener switch assembly.
Check operation of the lock switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Position | Specified Condition |
|---|---|---|
| 1 (L) - 2 (E) | Back door lock switch not pushed | 10 kΩ or higher |
| 1 (L) - 2 (E) | Back door lock switch pushed | Below 1 Ω |
| *a | Component without harness connected
(Back Door Opener Switch Assembly) |
If the result is not specified, replace the back door opener switch assembly.