Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR › 2011.12–2017.06
RM2170E _59 Vehicle Exterior _057047 MIRROR (EXT) _0278168 OUTER REAR VIEW MIRROR G

MIRROR (EXT)  OUTER REAR VIEW MIRROR  INSPECTION  


PROCEDURE

Hide 87940 1.INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH

a.

Check the operation of the mirror surface.

i.
B281822E01
0.109,0.069 0.292,0.244 0.184,0.174 10 *a 1.661,2.573 1.661,2.063 1.661,2.063 2.102,2.063 false 1.386,2.573 1.386,1.868 1.386,1.868 1.122,1.868 false 1.523,2.573 1.523,1.776 1.523,1.776 1.901,1.776 false 0.825,1.782 1.064,1.929 0.239,0.147 10 MH 2.131,1.982 2.371,2.129 0.239,0.147 10 MV 1.942,1.69 2.182,1.837 0.239,0.147 10 M+

Disconnect the outer rear view mirror assembly LH connector.


ii.

Apply auxiliary battery voltage and check the operation of the mirror.

OK:
Measurement Condition Specified Condition
Auxiliary battery positive (+) → Terminal 6 (MV)
Auxiliary battery negative (-) → Terminal 5 (M+)
Turns upward
Auxiliary battery positive (+) → Terminal 5 (M+)
Auxiliary battery negative (-) → Terminal 6 (MV)
Turns downward
Auxiliary battery positive (+) → Terminal 4 (MH)
Auxiliary battery negative (-) → Terminal 5 (M+)
Turns left
Auxiliary battery positive (+) → Terminal 5 (M+)
Auxiliary battery negative (-) → Terminal 4 (MH)
Turns right


Text in Illustration
*a Component without harness connected
(Outer Rear View Mirror Assembly LH)

If the result is not as specified, replace the outer rear view mirror assembly LH.



Hide 87940 2.INSPECT OUTER MIRROR RETRACTOR LH

a.

Check the operation of the retractable mirror. (w/ Power Retractable Mirror)

NOTICE:
·

Disconnect and reconnect the auxiliary battery between each mirror position check.

·

The mirror position cannot be changed manually when the auxiliary battery is connected. To change the mirror position manually, the auxiliary battery must be disconnected first.



i.
B199933E15
0.086,0.035 0.237,0.172 0.151,0.137 10 *a 1.184,0.035 1.334,0.172 0.151,0.137 10 *1 0.894,0.809 1.045,0.947 0.151,0.137 10 *2 1.033,1.645 1.184,1.782 0.151,0.137 10 *3 1.423,1.851 1.574,1.988 0.151,0.137 10 *4 2.031,2.026 2.182,2.164 0.151,0.137 10 *5 2.198,3.22 2.434,3.358 0.235,0.137 10 MR 1.201,3.22 1.421,3.358 0.220,0.137 10 MF 1.861,3.002 1.861,3.28 1.861,3.28 1.48,3.28 false 1.968,3.002 1.968,3.28 1.968,3.28 2.148,3.28 false

Disconnect the outer rear view mirror assembly LH connector.


ii.

For each position: Disconnect the auxiliary battery, set the mirror position by hand, connect the auxiliary battery, and check the retractable mirror's movement.

OK:
Tester Connection Condition Specified Condition
Auxiliary battery positive (+) → Terminal 11 (MR)
Auxiliary battery negative (-) → Terminal 10 (MF)
Forward position (A) Moves from (A) to retracted position (E)
Auxiliary battery positive (+) → Terminal 10 (MF)
Auxiliary battery negative (-) → Terminal 11 (MR)
Forward position (A) Does not move
Auxiliary battery positive (+) → Terminal 11 (MR)
Auxiliary battery negative (-) → Terminal 10 (MF)
Position between forward position (A) and driving position (C) Moves from (B) to retracted position (E)
Auxiliary battery positive (+) → Terminal 10 (MF)
Auxiliary battery negative (-) → Terminal 11 (MR)
Position between forward position (A) and driving position (C) Moves from (B) to forward position (A)
Auxiliary battery positive (+) → Terminal 11 (MR)
Auxiliary battery negative (-) → Terminal 10 (MF)
Driving position (C) Moves from (C) to retracted position (E)
Auxiliary battery positive (+) → Terminal 10 (MF)
Auxiliary battery negative (-) → Terminal 11 (MR)
Driving position (C) Does not move
Auxiliary battery positive (+) → Terminal 11 (MR)
Auxiliary battery negative (-) → Terminal 10 (MF)
Position between driving position (C) and retracted position (E) Moves from (D) to retracted position (E)
Auxiliary battery positive (+) → Terminal 10 (MF)
Auxiliary battery negative (-) → Terminal 11 (MR)
Position between driving position (C) and retracted position (E) Moves from (D) to driving position (C)
Auxiliary battery positive (+) → Terminal 11 (MR)
Auxiliary battery negative (-) → Terminal 10 (MF)
Retracted position (E) Does not move
Auxiliary battery positive (+) → Terminal 10 (MF)
Auxiliary battery negative (-) → Terminal 11 (MR)
Retracted position (E) Moves from (E) to driving position (C)


Text in Illustration
*1 (A) Forward Position
*2 (B)
*3 (C) Driving position
*4 (D)
*5 (E) Retracted Position
*a Component without harness connected
(Outer Mirror Retractor LH)

If the result is not as specified, replace the outer mirror retractor LH.



Hide 87910 3.INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH

a.

Check the operation of the mirror surface.

i.
B281818E01
2.454,2.57 2.454,1.616 2.454,1.616 2.661,1.616 false 2.325,2.57 2.325,1.782 2.325,1.782 2.199,1.782 false 2.593,2.57 2.593,1.975 2.593,1.975 2.8,1.975 false 1.879,1.707 2.119,1.853 0.239,0.145 10 MH 2.706,1.531 2.936,1.677 0.230,0.145 10 M+ 2.83,1.896 3.070,2.042 0.239,0.145 10 MV 0.095,0.075 0.269,0.212 0.174,0.137 10 *a

Disconnect the outer rear view mirror assembly RH connector.


ii.

Apply auxiliary battery voltage and check the operation of the mirror.

OK:
Measurement Condition Specified Condition
Auxiliary battery positive (+) → Terminal 6 (MV)
Auxiliary battery negative (-) → Terminal 5 (M+)
Turns upward
Auxiliary battery positive (+) → Terminal 5 (M+)
Auxiliary battery negative (-) → Terminal 6 (MV)
Turns downward
Auxiliary battery positive (+) → Terminal 4 (MH)
Auxiliary battery negative (-) → Terminal 5 (M+)
Turns left
Auxiliary battery positive (+) → Terminal 5 (M+)
Auxiliary battery negative (-) → Terminal 4 (MH)
Turns right


Text in Illustration
*a Component without harness connected
(Outer Rear View Mirror Assembly RH)

If the result is not as specified, replace the outer rear view mirror assembly RH.



Hide 87910 4.INSPECT OUTER MIRROR RETRACTOR RH

a.

Check the operation of the retractable mirror. (w/ Power Retractable Mirror)

NOTICE:
·

Disconnect and reconnect the auxiliary battery between each mirror position check.

·

The mirror position cannot be changed manually when the auxiliary battery is connected. To change the mirror position manually, the auxiliary battery must be disconnected first.



i.
B199932E16
0.126,0.083 0.277,0.222 0.151,0.138 10 *a 2.12,0.083 2.271,0.222 0.151,0.138 10 *1 2.406,0.897 2.557,1.035 0.151,0.138 10 *2 2.235,1.688 2.386,1.826 0.151,0.138 10 *3 1.299,3.239 1.520,3.377 0.220,0.138 10 MF 2.204,3.239 2.460,3.377 0.255,0.138 10 MR 1.834,1.905 1.984,2.043 0.151,0.138 10 *4 1.217,2.132 1.368,2.270 0.151,0.138 10 *5 1.977,2.99 1.977,3.315 1.977,3.315 2.183,3.315 false 1.865,2.99 1.865,3.315 1.865,3.315 1.587,3.315 false

Disconnect the outer rear view mirror assembly RH connector.


ii.

For each position: Disconnect the auxiliary battery, set the mirror position by hand, connect the auxiliary battery, and check the retractable mirror's movement.

OK:
Tester Connection Condition Specified Condition
Auxiliary battery positive (+) → Terminal 11 (MR)
Auxiliary battery negative (-) → Terminal 10 (MF)
Forward position (A) Moves from (A) to retracted position (E)
Auxiliary battery positive (+) → Terminal 10 (MF)
Auxiliary battery negative (-) → Terminal 11 (MR)
Forward position (A) Does not move
Auxiliary battery positive (+) → Terminal 11 (MR)
Auxiliary battery negative (-) → Terminal 10 (MF)
Position between forward position (A) and driving position (C) Moves from (B) to forward position (E)
Auxiliary battery positive (+) → Terminal 10 (MF)
Auxiliary battery negative (-) → Terminal 11 (MR)
Position between forward position (A) and driving position (C) Moves from (B) to retracted position (A)
Auxiliary battery positive (+) → Terminal 11 (MR)
Auxiliary battery negative (-) → Terminal 10 (MF)
Driving position (C) Moves from (C) to retracted position (E)
Auxiliary battery positive (+) → Terminal 10 (MF)
Auxiliary battery negative (-) → Terminal 11 (MR)
Driving position (C) Does not move
Auxiliary battery positive (+) → Terminal 11 (MR)
Auxiliary battery negative (-) → Terminal 10 (MF)
Position between driving position (C) and retracted position (E) Moves from (D) to retracted position (E)
Auxiliary battery positive (+) → Terminal 10 (MF)
Auxiliary battery negative (-) → Terminal 11 (MR)
Position between driving position (C) and retracted position (E) Moves from (D) to driving position (C)
Auxiliary battery positive (+) → Terminal 11 (MR)
Auxiliary battery negative (-) → Terminal 10 (MF)
Retracted position (E) Does not move
Auxiliary battery positive (+) → Terminal 10 (MF)
Auxiliary battery negative (-) → Terminal 11 (MR)
Retracted position (E) Moves from (E) to driving position (C)


Text in Illustration
*1 (A) Forward Position
*2 (B)
*3 (C) Driving position
*4 (D)
*5 (E) Retracted Position
*a Component without harness connected
(Outer Mirror Retractor RH)

If the result is not as specified, replace the outer mirror retractor RH.