81740
1.REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY
2.REMOVE OUTER MIRROR RETRACTOR
Cut the wire harness at the position shown in the illustration.
| *a | Cut the wire harness here |
Remove the vinyl tape from the gasket.
Disengage the 2 claws and 7 guides to remove the gasket.
Disengage the 4 claws and remove the stay cover.
Remove the 3 screws and stay.
Remove the 3 screws and disconnect the unit drive assembly.
Disengage the clamp.
Disconnect the connector and remove the unit drive assembly.
Remove the 5 screws and reinforcement.
Disconnect the connector.
Disengage the 2 clamps.
Remove the wire harness as shown in the illustration.
Make sure to replace the wire harness with a new one.
Remove the screw and retractor assembly.
Make sure to replace the retractor assembly with a new one.