Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
87961
1.REMOVE OUTER MIRROR
Push the upper part of the outer mirror surface and tilt it.
| *1 | Protective Tape |
| *2 | Moulding Remover |
Apply protective tape to the lower of the outer rear view mirror assembly with cover.
Using a moulding remover, disengage the 2 claws at the lower part of the outer rear view mirror assembly with cover, and separate the outer mirror.
Do not pull the outer mirror with excessive force. Doing so may cause the actuator to come off or break the mirror surface.
Push the lower part of the mirror surface and tilt it.
Apply protective tape to the upper of the outer rear view mirror assembly with cover.
| *1 | Protective Tape |
| *2 | Moulding Remover |
Using a moulding remover, disengage the 2 claws at the upper part of the outer rear view mirror assembly with cover, and remove the outer mirror.
Do not pull the outer mirror with excessive force. Doing so may cause the actuator to come off or break the mirror surface.