Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR(for Rear Side)
RM2170E _59 Vehicle Exterior _057048 WIPER / WASHER _0278179 WASHER MOTOR(for Rear Side) G

WIPER / WASHER  WASHER MOTOR(for Rear Side)  INSPECTION  


PROCEDURE

Hide 85330F 1.INSPECT REAR WASHER MOTOR AND PUMP ASSEMBLY

a.

Remove the washer jar.


b.

Disconnect the rear washer motor and pump assembly connector.

HINT:

The check should be performed with the rear washer motor and pump assembly installed on the washer jar.



c.

Fill the washer jar with washer fluid.


d.
U183720E02
1.594,0.208 1.865,0.385 0.271,0.177 10 false A20 0.104,0.01 0.26,0.188 0.156,0.177 10 false *a

Connect an auxiliary battery positive (+) lead to terminal 1 of the rear washer motor, and a negative (-) lead to terminal 2.


e.

Check that washer fluid flows from the washer jar.

OK:

Washer fluid flows from the washer jar.


Text in Illustration
*a Component without harness connected
(Rear Washer Motor and Pump Assembly)

If the result is not as specified, replace the rear washer motor and pump assembly.