Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER SWITCH › 2011.12–2014.12
RM2170E _59 Vehicle Exterior _057048 WIPER / WASHER _0278184 HEADLIGHT CLEANER SWITCH G

WIPER / WASHER  HEADLIGHT CLEANER SWITCH  INSPECTION  


PROCEDURE

Hide 84150D 1.INSPECT HEADLIGHT CLEANER SWITCH ASSEMBLY

U183721E01
1.571,0.163 1.854,0.338 0.283,0.174 10 G64 0.095,0.064 0.255,0.238 0.159,0.174 10 *a 2.067,1.127 2.659,1.679 false 1.861,1.127 2.109,1.679 false 1.404,1.127 0.812,1.679 false 1.61,1.127 1.362,1.679 false 0.658,1.704 0.795,1.850 0.137,0.147 10 B 2.66,1.704 2.798,1.850 0.137,0.147 10 E 1.182,1.704 1.486,1.850 0.304,0.147 10 ILL+ 1.973,1.704 2.277,1.850 0.304,0.147 10 ILL-

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (E) - 4 (B) Headlight cleaner switch on Below 1 Ω
Headlight cleaner switch off 10 kΩ or higher



b.

Connect an auxiliary positive (+) lead from the battery to terminal 3 (ILL+) and a negative (-) lead to terminal 2 (ILL-).


c.

Check that the headlight cleaner switch assembly illumination comes on.

OK:

The headlight cleaner switch assembly illumination comes on.


Text in Illustration
*a Component without harness connected
(Headlight Cleaner Switch Assembly)

If the result is not as specified, replace the headlight cleaner switch assembly.