Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
81560
1.INSTALL REAR COMBINATION LIGHT ASSEMBLY
Engage the grommet.
Engage the guide and 2 pins to temporarily install the rear combination light assembly.
| *a | Pin |
| *b | Guide |
| *3 | Rear Combination Light Guide |
| *3 | No. 2 Rear Combination Light Guide |
If the pins have a problem such as play, replace the rear combination light guide and No. 2 rear combination light guide with new ones.
Install the rear combination light assembly with the 2 bolts.
Pull the deck trim side panel assembly until the connector of the rear combination light assembly can be seen.
Connect the connector.
Engage the 2 clips to install the deck trim side panel assembly.
Install the bolt.