81536A
1.INSPECT REAR COMBINATION LED LIGHT (STOP LIGHT)
Disconnect the rear combination light socket and wire sub-assembly LH or RH.
Apply auxiliary battery voltage to the rear combination LED light and check that the light comes on.
| Tester Connection | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → Terminal 1
Auxiliary battery negative (-) → Terminal 2 |
The stop light comes on |
| *a | Component without harness connected
(Rear Combination LED Light (Stop Light)) |
If the result is not as specified, replace the rear combination LED light (stop light).
81565
2.INSPECT REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY LH
Reconnect the rear combination light socket and wire sub-assembly LH.
Apply auxiliary battery voltage to the rear combination light socket and wire sub-assembly LH and check that the light comes on.
| Tester Connection | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → Terminal 2 (B)*1
Auxiliary battery negative (-) → Terminal 1 (E) |
The back-up light comes on |
| Auxiliary battery positive (+) → Terminal 3 (B)
Auxiliary battery negative (-) → Terminal 1 (E) |
The stop light comes on |
| Auxiliary battery positive (+) → Terminal 4 (B)
Auxiliary battery negative (-) → Terminal 1 (E) |
The taillight comes on |
| Auxiliary battery positive (+) → Terminal 5 (B)
Auxiliary battery negative (-) → Terminal 1 (E) |
The turn signal light comes on |
| Auxiliary battery positive (+) → Terminal 6 (B)*2
Auxiliary battery negative (-) → Terminal 1 (E) |
The rear fog light comes on |
*1: w/o Rear Fog Light
*2: w/ Rear Fog Light
| *A | w/o Rear Fog Light |
| *B | w/ Rear Fog Light |
| *a | Component without harness connected
(Rear Combination Light Socket and Wire Sub-assembly LH) |
If the result is not as specified, replace the rear combination light socket and wire sub-assembly LH.
81555
3.INSPECT REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY RH
Reconnect the rear combination light socket and wire sub-assembly RH.
Apply auxiliary battery voltage to the rear combination light socket and wire sub-assembly RH and check that the light comes on.
| Tester Connection | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → Terminal 2 (B)
Auxiliary battery negative (-) → Terminal 1 (E) |
The back-up light comes on |
| Auxiliary battery positive (+) → Terminal 3 (B)
Auxiliary battery negative (-) → Terminal 1 (E) |
The stop light comes on |
| Auxiliary battery positive (+) → Terminal 4 (B)
Auxiliary battery negative (-) → Terminal 1 (E) |
The taillight comes on |
| Auxiliary battery positive (+) → Terminal 5 (B)
Auxiliary battery negative (-) → Terminal 1 (E) |
The turn signal light comes on |
| *a | Component without harness connected
(Rear Combination Light Socket and Wire Sub-assembly RH) |
If the result is not as specified, replace the rear combination light socket and wire sub-assembly RH.