84152
1.INSPECT HEADLIGHT LEVELING SWITCH
Voltage Check
Connect a positive (+) lead from the auxiliary battery to terminal 1 (B) and a negative (-) lead to terminal 4 (E).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Position | Specified Condition |
|---|---|---|
| 2 (T) - 4 (E) | 0 | 8.7 to 13.0 V |
| 1 | 7.6 to 11.5 V | |
| 2 | 6.6 to 10.0 V | |
| 3 | 5.5 to 8.5 V | |
| 4 | 4.4 to 7.0 V | |
| 5 | 3.4 to 5.6 V |
Auxiliary battery voltage is 12 V.
| *a | Component without harness connected
(Headlight Leveling Switch) |
If the result is not as specified, replace the headlight leveling switch.
Illumination Inspection
Apply auxiliary battery voltage to the headlight leveling switch and check that the switch illuminates.
| Tester Connection | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → Terminal 3 (ILL+)
Auxiliary battery negative (-) → Terminal 4 (E) |
Illuminates |
| *a | Component without harness connected
(Headlight Leveling Switch) |
If the result is not as specified, replace the headlight leveling switch.