Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR
RM2170E _59 Vehicle Exterior _057049 LIGHTING (EXT) _0278192 HEIGHT CONTROL SENSOR G

LIGHTING (EXT)  HEIGHT CONTROL SENSOR  INSPECTION  


PROCEDURE

Hide 89407A 1.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY

a.

Connect 3 dry cell batteries (1.5 V) in series.

NOTICE:

Do not use rechargeable batteries as they may not output a voltage of 1.5 V.



b.

Connect the positive (+) lead from the batteries to terminal 3 (SHB) and the negative (-) lead from the batteries to terminal 1 (SHG).

E151424E05
5.885,2 5.885,2.49 false 5.698,1.99 5.385,2.469 false 6.073,2 6.448,2.479 false 0.188,0.135 0.458,0.396 0.271,0.26 10 false *a 3.219,0.354 3.49,0.615 0.271,0.26 10 false *b 4.25,1.427 4.521,1.688 0.271,0.26 10 false *c 4.031,2.875 4.302,3.135 0.271,0.26 10 false *d 5.219,2.5 5.719,2.698 0.5,0.198 10 false SHB 6.344,2.521 6.844,2.719 0.5,0.198 10 false SHG 5.708,2.521 6.208,2.719 0.5,0.198 10 false SHRR 3.833,0.813 4.271,1.073 0.438,0.26 10 false -45° 4.198,2.448 4.635,2.708 0.438,0.26 10 false +45° 4.302,1.719 4.865,1.979 0.563,0.26 10 false -17.6°

Text in Illustration
*a Component without harness connected
(Rear Height Control Sensor Sub-assembly)
*b Low
*c Normal *d High


c.

Measure the voltage between terminals 2 (SHRR) and 1 (SHG) while slowly moving the link up and down.

Standard Voltage:
Tester Connection Condition Specified Condition
2 (SHRR) - 1 (SHG) +45°(High) 4.05 V
2 (SHRR) - 1 (SHG) 0°(Normal) 2.25 V
2 (SHRR) - 1 (SHG) -45°(Low) 0.45 V