PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following system after the cable is reconnected:
| System | See Procedure |
|---|---|
| Power Door Lock Control System | ( )
|
PRECAUTIONS WHEN USING INTELLIGENT TESTER
When using the intelligent tester with the power switch off to troubleshoot: Connect the intelligent tester to the vehicle, and turn a courtesy light switch on and off at 1.5 second or less intervals until communication between the intelligent tester and vehicle begins.
After all DTCs are cleared, check if the trouble occurs again 6 seconds after turning the power switch on (IG).