The headlight leveling ECU assembly actuates the headlight leveling motors according to vehicle conditions.
Connect the intelligent tester to the DLC3.
Turn the power switch on (Ready).
Turn the intelligent tester on.
Enter the following menus: Body / HL Auto Leveling / Active Test.
Check that the leveling motors operate.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Drive The Leveling Motor UP | Leveling motor upward operation | ON/OFF | ON: Moves up
OFF: Stops |
| Drive The Leveling Motor DOWN | Leveling motor downward operation | ON/OFF | ON: Moves down
OFF: Stops |
Headlight leveling motors operate normally.
OK
(See pageVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE)
NG
Disconnect the A34 headlight leveling ECU assembly connector.
Disconnect the LH side or RH side headlight leveling motor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A34-18 (LHT) - A57-2 (LH T) | Always | Below 1 Ω |
| A34-11 (LH+) - A57-3 (LHIG) | Always | Below 1 Ω |
| A34-24 (LH-) - A57-1 (LH E) | Always | Below 1 Ω |
| A34-18 (LHT) - Body ground | Always | 10 kΩ or higher |
| A34-11 (LH+) - Body ground | Always | 10 kΩ or higher |
| A34-24 (LH-) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A34-17 (RHT) - A56-2 (RH T) | Always | Below 1 Ω |
| A34-10 (RH+) - A56-3 (RHIG) | Always | Below 1 Ω |
| A34-23 (RH-) - A56-1 (RH E) | Always | Below 1 Ω |
| A34-17 (RHT) - Body ground | Always | 10 kΩ or higher |
| A34-10 (RH+) - Body ground | Always | 10 kΩ or higher |
| A34-23 (RH-) - Body ground | Always | 10 kΩ or higher |
OK
NG
Replace the headlight leveling motor with a new or a known good one (See page Vehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for LED Headlight)>REMOVAL).
Perform the active test of the leveling motors.
Headlight leveling motors operate normally.
OK
NG