Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM › 2011.12–2019.07
RM2170E _59 Vehicle Exterior _057049 LIGHTING (EXT) _0278195 AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM J

LIGHTING (EXT)  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM  Headlight Leveling ECU Power Source Circuit  


DESCRIPTION

This circuit detects the state of the power switch, and sends it to the headlight leveling ECU assembly.

WIRING DIAGRAM

E223770E05
4.846,2.76 7.019,2.947 2.173,0.186 10 Headlight Leveling ECU Assembly 4.846,2.58 5.123,2.766 0.277,0.186 10 A34 0.612,1.066 1.979,1.248 1.367,0.182 10 from IG1 NO. 1 Relay 5.481,1.081 5.676,1.280 0.195,0.200 10 IG 5.476,2.17 5.671,2.370 0.195,0.200 10 E1 5.285,2.064 5.386,2.215 0.101,0.150 10 9 5.266,0.967 5.392,1.146 0.126,0.179 10 1 3.368,1.225 4.282,1.421 0.914,0.196 10 ECU-IG NO. 1

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / HL Auto Leveling / Data List.


e.

Read the display on the intelligent tester.

HL Auto Leveling
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
+B IG power supply voltage value / 0.00 to 19.75 V 11 to 14 V -

OK:

Normal condition listed above is displayed.




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.CHECK HARNESS AND CONNECTOR (AUXILIARY BATTERY - HEADLIGHT LEVELING ECU ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (AUXILIARY BATTERY - HEADLIGHT LEVELING ECU ASSEMBLY)
a.

Disconnect the A34 headlight leveling ECU assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A34-1 (IG) - Body ground Power switch on (IG) 11 to 14 V
A34-1 (IG) - Body ground Power switch off Below 1 V




OK

3.CHECK HARNESS AND CONNECTOR (HEADLIGHT LEVELING ECU ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK HARNESS AND CONNECTOR (HEADLIGHT LEVELING ECU ASSEMBLY - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A34-9 (E1) - Body ground Always Below 1 Ω




OK

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR