Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM › 2011.12–2019.07
RM2170E _59 Vehicle Exterior _057049 LIGHTING (EXT) _0278195 AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM J

LIGHTING (EXT)  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM  Headlight Signal Circuit  


DESCRIPTION

The headlight leveling ECU assembly detects the status of the low beam headlights.

WIRING DIAGRAM

E245310E04
2.563,1.833 3.313,2.01 0.75,0.177 10 false H-LP 4.875,1.229 5.104,1.406 0.229,0.177 10 false 3 1.135,1.49 2.01,1.677 0.875,0.188 10 false H-LP MAIN 5.073,1.344 5.479,1.521 0.406,0.177 10 false HDLP 4.948,1.865 5.354,2.042 0.406,0.177 10 false A34 4.958,2.021 6.438,2.438 1.479,0.417 10 false Headlight Leveling ECU Assembly 2.125,1.219 2.313,1.396 0.188,0.177 10 false 1 3.125,1.229 3.313,1.406 0.188,0.177 10 false 2 2.135,1.458 2.323,1.635 0.188,0.177 10 false 5 3.125,1.469 3.313,1.646 0.188,0.177 10 false 3 2.031,0.594 3.448,0.792 1.417,0.198 10 false from Auxiliary Battery 1.479,2.198 3.104,2.427 1.625,0.229 10 false to Low Beam Headlight

CAUTION / NOTICE / HINT

NOTICE:

First check that the low beam headlights operate normally.


PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / HL Auto Leveling / Data List.


e.

Read the display on the intelligent tester.

HL Auto Leveling
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Headlight Low Beam State Low beam headlight state/ON or OFF ON: Low beam headlights on
OFF: Low beam headlights off
-

OK:

Normal conditions listed above are displayed.




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.CHECK HARNESS AND CONNECTOR (H-LP RELAY - HEADLIGHT LEVELING ECU ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (H-LP RELAY - HEADLIGHT LEVELING ECU ASSEMBLY)
a.

Remove the H-LP relay from the No. 2 engine room relay block and No. 2 junction block assembly.


b.

Disconnect the A34 headlight leveling ECU assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Relay terminal 2 - A34-3 (HDLP) Always Below 1 Ω
Relay terminal 2 - Body ground Always 10 kΩ or higher




OK

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR