Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM › 2011.12–2019.07
RM2170E _59 Vehicle Exterior _057049 LIGHTING (EXT) _0278195 AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM C

LIGHTING (EXT)  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM  B2452  Height Control Sensor Data Out of Range When Initializing  


DESCRIPTION

The headlight leveling ECU assembly stores this DTC if the sensor value received from the height control sensor is out of range when performing initialization of the headlight leveling ECU assembly; for example, the vehicle is not level or being jacked up.

DTC No. DTC Detecting Condition Trouble Area
B2452 Vehicle condition not specified when initializing
·

Vehicle condition when initializing

·

Headlight leveling ECU assembly



CAUTION / NOTICE / HINT

NOTICE:

If the headlight leveling ECU assembly has been replaced, initialization of the headlight leveling ECU assembly is necessary (See page Vehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION).


PROCEDURE

1.PERFORM INITIALIZATION
a.

Perform initialization of the headlight leveling ECU assembly (See page Vehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION).

HINT:
·

Before initializing the headlight leveling ECU assembly, make sure that the vehicle condition is proper for initialization.

·

Be sure to perform initialization as instructed.





NEXT

2.RECHECK FOR DTC
2.RECHECK FOR DTC
a.

Using the intelligent tester, recheck for DTCs (See page Vehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>DTC CHECK / CLEAR).

OK:

DTC B2452 is not output


HINT:

If the headlight leveling ECU assembly stores DTC B2452 even though the ECU has been initialized as instructed, there may be a malfunction in the headlight leveling ECU assembly.




OK

END

NG

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY