Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM › 2011.12–2017.06
RM2170E _59 Vehicle Exterior _057049 LIGHTING (EXT) _0278196 LIGHTING SYSTEM D

LIGHTING (EXT)  LIGHTING SYSTEM  SYSTEM DESCRIPTION  


LIGHT AUTO TURN-OFF SYSTEM


a.

General

The light auto turn-off system is used to prevent the exterior lights from being accidentally left on (headlights, front fog lights, taillights, parking lights, license plate lights and rear fog light).


b.

When all of the following conditions are met, the headlights, front fog lights, taillights, parking lights, license plate lights and rear fog light turn off:

·

The power switch is turned from on (IG) to off.

·

The headlights, front fog lights, taillights, parking lights, license plate lights and rear fog light are on.

·

The driver door is opened.




LED HEADLIGHT SYSTEM


a.

General

LED headlights are used to provide efficient, maintenance free lighting. Compared to halogen or HID headlights, even if an LED headlight is used for a long time, the reduction of brightness over its lifetime is less. In addition, there is no possibility of an LED having an open circuit because of vibration.


b.

Function of Main Components

Component Outline
Light Control ECU
·

Turns on the LEDs immediately when the light control switch is turned to the head position.

·

Regulates the output current flowing into the LEDs at a specified level to prevent the light from getting brighter and dimmer due to voltage variation.

·

Transmits fail signals to the main body ECU (multiplex network body ECU) when a malfunction occurs in the LED headlight system.


Combination Meter Assembly Master Warning Light Flashes to inform the driver when the light control ECU detects malfunctions in this system.
Multi-information Display Displays a warning message to inform the driver when the light control ECU detects a malfunction in this system.
Main Body ECU (Multiplex Network Body ECU)
·

Receives fail signals from the light control ECU when a malfunction occurs in the LED headlight system, and transmits the signals to the combination meter assembly.

·

Stores Diagnostic Trouble Codes (DTCs) when the system malfunctions.