Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM › 2011.12–2014.12
RM2170E _59 Vehicle Exterior _057049 LIGHTING (EXT) _0278196 LIGHTING SYSTEM U

LIGHTING (EXT)  LIGHTING SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuator and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / (desired system) / Data List.


e.

Read the Data List according to the display on the intelligent tester.

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Dimmer SW Dimmer switch high position signal/ON or OFF ON: Dimmer switch in high or high flash position
OFF: Dimmer switch in low position
-
Passing Light SW Dimmer switch high flash position (pass) signal/ON or OFF ON: Dimmer switch in high flash position
OFF: Dimmer switch not in high flash position
-
Rear Fog Light SW*1 Rear fog light switch signal/ON or OFF ON: Rear fog light switch on
OFF: Rear fog light switch off
-
Front Fog Light SW Front fog light switch signal/ON or OFF ON: Front fog light switch on
OFF: Front fog light switch off
-
Head Light SW (Head) Light control switch head position signal/ON or OFF ON: Light control switch in head position
OFF: Light control switch not in head position
-
Head Light SW (Tail) Light control switch tail position signal/ON or OFF ON: Light control switch in tail or head position
OFF: Light control switch in neither tail nor head position
-

*1: w/ Rear Fog Light


Combination Meter
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Turn Signal Switch (Right) Turn signal switch (Right) signal/ON or OFF ON: Turn signal switch (Right) on
OFF: Turn signal switch (Right) off
-
Turn Signal Switch (Left) Turn signal switch (Left) signal/ON or OFF ON: Turn signal switch (Left) on
OFF: Turn signal switch (Left) off
-
Hazard Flasher Switch Hazard switch signal/ON or OFF ON: Hazard switch on
OFF: Hazard switch off
-



ACTIVE TEST


HINT:

Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Main Body / Active Test.


e.

Perform the Active Test according to the display on the intelligent tester.

Main Body
Tester Display Test Part Control Range Diagnostic Note
Taillight Relay Taillight relay ON/OFF -
Headlight Relay Headlight relay (low beam headlights) ON/OFF -
Head Light Hi High beam headlights ON/OFF -
Front Fog Light Relay Front fog light relay ON/OFF Light control switch is in tail position
Rear Fog Light Relay*1 Rear fog light relay ON/OFF Light control switch is in tail position

*1: w/ Rear Fog Light