DATA LIST
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / (desired system) / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Dimmer SW | Dimmer switch high position signal/ON or OFF | ON: Dimmer switch in high or high flash position
OFF: Dimmer switch in low position |
*1 |
| Passing Light SW | Dimmer switch high flash position (pass) signal/ON or OFF | ON: Dimmer switch in high flash position
OFF: Dimmer switch not in high flash position |
*1 |
| Front Fog Light SW | Front fog light switch signal/ON or OFF | ON: Front fog light switch on
OFF: Front fog light switch off |
*1, *2 |
| Head Light SW (Head) | Light control switch head position signal/ON or OFF | ON: Light control switch in head position
OFF: Light control switch not in head position |
*1 |
| Head Light SW (Tail) | Light control switch tail position signal/ON or OFF | ON: Light control switch in tail or head position
OFF: Light control switch in neither tail nor head position |
- |
*1: w/ Light Auto Turn-off System
*2: w/ Front Fog Light
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Turn Signal Switch (Right) | Turn signal switch (right) signal/ON or OFF | ON: Turn signal switch (right) on
OFF: Turn signal switch (right) off |
- |
| Turn Signal Switch (Left) | Turn signal switch (left) signal/ON or OFF | ON: Turn signal switch (left) on
OFF: Turn signal switch (left) off |
- |
| Hazard Flasher Switch | Hazard switch signal/ON or OFF | ON: Hazard switch on
OFF: Hazard switch off |
- |
ACTIVE TEST
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Active Test.
Perform the Active Test according to the display on the intelligent tester.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Taillight Relay | Taillight relay | ON/OFF | *1 |
| Headlight Relay | Headlight relay (low beam headlights) | ON/OFF | *1 |
| Head Light Hi | High beam headlights | ON/OFF | *1 |
| Front Fog Light Relay | Front fog light relay | ON/OFF | Light control switch is in tail position*1, *2 |
*1: w/ Light Auto Turn-off System
*2: w/ Front Fog Light