Home › Vehicle Exterior › LIGHTING (EXT) › LICENSE PLATE LIGHT ASSEMBLY
RM2170E _59 Vehicle Exterior _057049 LIGHTING (EXT) _0278199 LICENSE PLATE LIGHT ASSEMBLY A

LIGHTING (EXT)  LICENSE PLATE LIGHT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 67750 1.REMOVE BACK DOOR TRIM BOARD ASSEMBLY

Hide 81270 2.REMOVE LICENSE PLATE LIGHT ASSEMBLY

a.
E237720

Disconnect the connector.


b.

Disengage the 2 claws and remove the license plate light assembly.


Hide 81274B 3.REMOVE LICENSE PLATE LIGHT PACKING

a.

Remove the license plate light packing.

NOTICE:

Do not reuse the removed packing. Be sure to install a new license plate light packing to prevent water ingress.



Hide 81271 4.REMOVE LICENSE PLATE LIGHT LENS

a.
E248509

Using a screwdriver, disengage the 2 claws and remove the license plate light lens from the housing.


Hide 81270B 5.REMOVE LICENSE PLATE LIGHT BULB

a.

Remove the license plate light bulb from the housing.