Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH
RM2170E _59 Vehicle Exterior _057049 LIGHTING (EXT) _0278202 HAZARD WARNING SWITCH G

LIGHTING (EXT)  HAZARD WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 84330 1.INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY

a.
E136319E30
0.175,0.136 0.477,0.382 0.302,0.246 10 *a 0.696,1.34 0.915,1.493 0.219,0.153 10 TB 2.561,1.318 2.710,1.473 0.149,0.155 10 E 2.029,1.418 2.527,1.418 false 1.411,1.419 0.96,1.419 false

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 (TB) - 1 (E) Hazard warning signal switch off 10 kΩ or higher
Hazard warning signal switch on Below 1 Ω


Text in Illustration
*a Component without harness connected
(Hazard Warning Signal Switch Assembly)

If the result is not as specified, replace the hazard warning signal switch assembly.


b.

Illumination Inspection

i.
E136319E29
0.175,0.157 0.477,0.403 0.302,0.246 10 *a 0.906,0.78 1.220,0.934 0.314,0.154 10 ILL+ 2.196,0.78 2.493,0.937 0.297,0.157 10 ILL- 1.616,1.363 1.218,0.955 false 1.834,1.362 2.241,0.976 false

Apply auxiliary battery voltage to the hazard warning signal switch assembly and check that the switch illuminates.

OK:
Tester Connection Specified Condition
Auxiliary battery positive (+) → Terminal 3 (ILL+)
Auxiliary battery negative (-) → Terminal 2 (ILL-)
Illuminates


Text in Illustration
*a Component without harness connected
(Hazard Warning Signal Switch Assembly)

If the result is not as specified, replace the hazard warning signal switch assembly.