Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH › 2013.12–2017.06
RM2170E _59 Vehicle Exterior _057049 LIGHTING (EXT) _0278203 STOP LIGHT SWITCH G

LIGHTING (EXT)  STOP LIGHT SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 84340 1.INSPECT STOP LIGHT SWITCH ASSEMBLY

a.
U183739N01
1.708,1.313 1.76,1.729 false 1.354,1.323 1.177,1.729 false 2.094,1.302 2.271,1.719 false 0.104,0.063 0.333,0.24 0.229,0.177 10 false *a 1.573,0.271 1.875,0.448 0.302,0.177 10 false A65 1.073,1.74 1.219,1.917 0.146,0.177 10 false B 1.573,1.75 1.896,1.927 0.323,0.177 10 false GND 2.229,1.729 2.552,1.906 0.323,0.177 10 false B*A

Disconnect the A65 connector from the stop light switch assembly.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A65-1 (B) - A65-3 (GND) Power switch off 11 to 14 V
A65-5 (B) - A65-3 (GND)*1 Power switch on (IG) 11 to 14 V


*1: w/ Cruise Control System


Text in Illustration
*A w/ Cruise Control System
*a Front view of wire harness connector
(to Stop Light Switch Assembly)

If the result is not as specified, replace the stop light switch assembly.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A65-3 (GND) - Body ground Always Below 1 Ω



d.
U183741N01
1.521,1.323 1.323,1.708 false 1.938,1.323 2.323,1.604 false 1.729,1.333 2.01,1.885 false 0.198,0.073 0.427,0.25 0.229,0.177 10 false *a 1.583,0.344 1.865,0.521 0.281,0.177 10 false A65 1.865,1.896 2.188,2.073 0.323,0.177 10 false GND 2.25,1.635 2.563,1.813 0.313,0.177 10 false OUT 1.198,1.729 1.521,1.906 0.323,0.177 10 false L*A

Reconnect the A65 connector to the stop light switch assembly.


e.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A65-2 (OUT) - A65-3 (GND) Power switch off, brake pedal not depressed Below 1 V
A65-2 (OUT) - A65-3 (GND) Power switch off, brake pedal depressed 11 to 14 V
A65-4 (L) - A65-3 (GND)*1 Power switch on (IG), brake pedal not depressed 11 to 14 V
A65-4 (L) - A65-3 (GND)*1 Power switch on (IG), brake pedal depressed Below 1 V


*1: w/ Cruise Control System


Text in Illustration
*A w/ Cruise Control System
*a Component with harness connected
(Stop Light Switch Assembly)

If the result is not as specified, replace the stop light switch assembly.