Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER(w/o Wheel Opening Moulding) › 2011.12–2014.12
RM2170E _59 Vehicle Exterior _057051 EXTERIOR PANELS / TRIM _0278207 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT BUMPER ASSEMBLY

a.

w/ Headlight Cleaner System:

i.

Connect the headlight cleaner hose.



b.
B310559

Move the front bumper assembly into position and engage the 2 claws.


c.

Install the 3 clips.


d.

Pull back the side of the front bumper assembly and connect each connector.

NOTICE:

Do not apply excessive force when separating the front bumper.



e.
B310560

Engage the 4 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



f.
B310561E02
1.625,2.969 1.354,2.75 false 2.146,2.188 2.333,2.583 false 1.229,2.188 1.365,2.5 false 1.646,2.885 1.802,3.042 0.156,0.156 10 false *1 1.979,2.073 2.135,2.229 0.156,0.156 10 false *3 1.083,2.073 1.24,2.229 0.156,0.156 10 false *2

Install 2 new grommets as shown in the illustration.

Text in Illustration
*1 Engine Under Cover
*2 Front Bumper Cover
*3 Front Fender Liner


g.

Install the 2 bolts.


h.

Install the 6 screws and front bumper assembly.


Hide 2.ADD WASHER FLUID (w/ Headlight Cleaner System)

Hide 3.ADJUST FOG LIGHT ASSEMBLY