Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER(w/o Wheel Opening Moulding) › 2014.12–2017.06
RM2170E _59 Vehicle Exterior _057051 EXTERIOR PANELS / TRIM _0278207 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT BUMPER ASSEMBLY

a.
B392317

Move the front bumper assembly into position and engage the 2 claws.


b.

Install the 3 clips.


c.

Pull back the side of the front bumper assembly and connect each connector.

NOTICE:

Do not apply excessive force when separating the front bumper assembly.



d.
B392316

Engage the 4 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



e.
B392315E02
1.344,2.75 1.542,2.958 false 1.427,2.49 1.26,2.146 false 2.406,2.583 2.156,2.177 false 1.583,2.906 1.792,3.083 0.208,0.177 10 false *a 1.094,2 1.292,2.188 0.198,0.188 10 false *b 1.979,2.01 2.177,2.198 0.198,0.188 10 false *c

Install 2 new grommets as shown in the illustration.

Text in Illustration
*a Engine Under Cover
*b Front Bumper Cover
*c Front Fender Liner


f.

Install the 3 bolts.


g.

Install the front bumper assembly with the 5 screws.


Hide 2.ADJUST FOG LIGHT ASSEMBLY