1.REMOVE FRONT BUMPER ASSEMBLY
Apply protective tape, as shown in the illustration.
| *1 | Protective Tape |
Remove the 5 screws.
| *1 | Screw |
| *2 | Bolt |
Remove the 3 bolts.
Remove the 2 grommets as shown in the illustration.
| *1 | Engine Under Cover |
| *2 | Front Bumper Cover |
| *3 | Front Fender Liner |
Disengage the 4 claws as shown in the illustration.
Use the same procedure for the RH side and LH side.
Pull back the side of the front bumper assembly and disconnect each connector.
Do not apply excessive force when separating the front bumper.
Remove the 3 clips.
Disengage the 2 claws as shown in the illustration.
w/ Headlight Cleaner System:
Disconnect the headlight cleaner hose and drain the washer fluid.
Use a container to collect the washer fluid.
Remove the front bumper assembly.