1.REMOVE FRONT BUMPER ASSEMBLY
Apply protective tape around the front bumper assembly as shown in the illustration.
| *a | Protective Tape |
Remove the 5 screws.
| *a | Screw |
| *b | Bolt |
Remove the 3 bolts.
Remove the 2 grommets as shown in the illustration.
| *a | Engine Under Cover |
| *b | Front Bumper Cover |
| *c | Front Fender Liner |
Disengage the 4 claws as shown in the illustration.
Use the same procedure for the RH side and LH side.
Pull back the side of the front bumper assembly and disconnect each connector.
Do not apply excessive force when pulling back the front bumper assembly.
Remove the 3 clips.
Disengage the 2 claws to remove the front bumper assembly as shown in the illustration.