Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER(w/o Wheel Opening Moulding) › 2011.12–2017.06
RM2170E _59 Vehicle Exterior _057051 EXTERIOR PANELS / TRIM _0278208 REAR BUMPER A

EXTERIOR PANELS / TRIM  REAR BUMPER  REMOVAL  


PROCEDURE

Hide 58398J 1.REMOVE NO. 1 FLOOR UNDER COVER

a.
B297213

Remove the 5 clips and No. 1 floor under cover.


Hide 52461D 2.REMOVE REAR BUMPER CUSHION

a.
B307352

Using a T30 "TORX" socket wrench, remove the 2 rear bumper cushions.


Hide 3.REMOVE REAR BUMPER ASSEMBLY

a.
B256853E03
0.375,0.115 0.521,0.292 0.146,0.177 10 false A 1.615,0.49 1.76,0.667 0.146,0.177 10 false B

Apply protective tape, as shown in the illustration.

Text in Illustration
V100155

Protective Tape

HINT:
·

As shown in illustration A, while inserting protective tape into the gap between the rear bumper assembly and the rear combination light assembly, adhere the tape to the upper surface of the rear bumper assembly.

·

As shown in illustration B, while inserting protective tape into the gap between the rear bumper assembly and the rear combination light assembly, adhere the tape to the rear combination light assembly to cover the area from the tip to the far part of the inner side.




b.
B307354

Remove the 6 clips.


c.
B307355

Disengage the 5 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



d.
B307356

Disengage the 2 claws and remove the rear bumper assembly as shown in the illustration.