Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROOF DRIP SIDE FINISH MOULDING
RM2170E _59 Vehicle Exterior _057051 EXTERIOR PANELS / TRIM _0278214 ROOF DRIP SIDE FINISH MOULDING A

EXTERIOR PANELS / TRIM  ROOF DRIP SIDE FINISH MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 75561 1.INSTALL NO. 1 ROOF DRIP SIDE FINISH MOULDING CLIP

NOTICE:

When installing new clips, remove the double-sided tape remaining where the clips will be installed on the body and clean the body with a non-residue solvent.


a.

Apply a 2 to 3 mm (0.0787 to 0.118 in.) bead of adhesive (3M DP-105 or equivalent) to new roof drip side finish moulding clips.

HINT:

Adhesive strength (tensile strength): 13.7 MPa (140.0 kgf/cm2) or more (when the temperature is 23°C (73°F))



b.

Press and install the 2 roof drip side finish moulding clips.


c.
B298013E03
0.583,0.26 0.688,0.438 0.104,0.177 10 false a 1,0.313 1.104,0.49 0.104,0.177 10 false b 2.219,0.219 2.323,0.396 0.104,0.177 10 false c 0.625,3.385 0.729,3.563 0.104,0.177 10 false d 1.063,3.448 1.167,3.625 0.104,0.177 10 false e 2.781,3.5 2.885,3.677 0.104,0.177 10 false f

Install 2 new clips to the positions on the roof panel shown in the illustration. Determine the locations and firmly press and install the 2 roof drip side finish moulding clips after lightly applying adhesive (3M DP-105 or equivalent).

Standard Measurement:
Dimension Measurement
a 2.0 mm (0.0787 in.)
b 3.4 mm (0.134 in.)
c 3.0 mm (0.118 in.)
d 2.0 mm (0.0787 in.)
e 4.9 mm (0.193 in.)
f 4.0 mm (0.157 in.)



d.

Install the roof drip center side finish moulding when 20 minutes or more have elapsed after pressing and installing 2 new roof drip side finish moulding clips.

HINT:
·

Initial hardening time: 20 minutes

·

Complete hardening time: 48 hours




Hide 75552 2.INSTALL ROOF DRIP SIDE FINISH MOULDING

a.

Engage the 2 clips and install the roof drip side finish moulding.