Home › Vehicle Exterior › VEHICLE PROXIMITY NOTIFICATION SYSTEM › VEHICLE APPROACHING SPEAKER SWITCH › 2015.11–2019.07
RM2170E _59 Vehicle Exterior _057056 VEHICLE PROXIMITY NOTIFICATION SYSTEM _0278226 VEHICLE APPROACHING SPEAKER SWITCH G

VEHICLE PROXIMITY NOTIFICATION SYSTEM  VEHICLE APPROACHING SPEAKER SWITCH  INSPECTION  


PROCEDURE

Hide 84431 1.INSPECT VEHICLE APPROACHING SPEAKER SWITCH

a.
E342322E03
1.24,1.719 1.542,1.271 false 2.458,1.708 2.156,1.26 false 0.156,0.115 0.344,0.281 0.188,0.167 10 false *a 1.167,1.74 1.354,1.906 0.188,0.167 10 false IG 2.417,1.729 2.76,1.896 0.344,0.167 10 false ECU

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G84-1 (ECU) - G84-4 (IG) Vehicle approaching speaker switch being pushed and held Below 1 Ω
G84-1 (ECU) - G84-4 (IG) Vehicle approaching speaker switch not pushed 10 kΩ or higher


Text in Illustration
*a Component without harness connected
(Vehicle Approaching Speaker Switch)

If the result is not as specified, replace the vehicle approaching speaker switch.


b.
E342322E04
1.438,1.719 1.729,1.271 false 2.229,1.719 1.938,1.271 false 0.156,0.115 0.344,0.281 0.188,0.167 10 false *a 2.146,1.729 2.49,1.896 0.344,0.167 10 false ILL- 1.24,1.729 1.583,1.896 0.344,0.167 10 false ILL+

Apply auxiliary battery voltage between the terminals of the switch, and check the illumination condition of the vehicle approaching speaker switch.

OK:
Measurement Condition Specified Condition
Auxiliary battery positive (+) → G84-3 (ILL+)
Auxiliary battery negative (-) → G84-2 (ILL-)
Illuminates


Text in Illustration
*a Component without harness connected
(Vehicle Approaching Speaker Switch)

If the result is not as specified, replace the vehicle approaching speaker switch.