Home › Vehicle Exterior › VEHICLE PROXIMITY NOTIFICATION SYSTEM › VEHICLE PROXIMITY NOTIFICATION SYSTEM › 2015.11–2019.07
RM2170E _59 Vehicle Exterior _057056 VEHICLE PROXIMITY NOTIFICATION SYSTEM _0278228 VEHICLE PROXIMITY NOTIFICATION SYSTEM C

VEHICLE PROXIMITY NOTIFICATION SYSTEM  VEHICLE PROXIMITY NOTIFICATION SYSTEM  B1350  Speaker Circuit  


DESCRIPTION

The vehicle approaching speaker assembly circuit consists of the vehicle approaching speaker controller and vehicle approaching speaker assembly.

This DTC is stored when a malfunction is detected in the vehicle approaching speaker assembly circuit.

DTC No. DTC Detection Condition Trouble Area
B1350 Either of the following conditions is met:
·

When sound output voltage is being monitored by the ECU, with the power switch on (IG), battery voltage 10 V or more, and warning sound being produced, a speaker circuit short condition continues for 1 second or more.

·

When sound output voltage is being monitored by the ECU, with the power switch on (IG) and warning sound not being produced, a speaker circuit open condition continues for 5 seconds or more.


·

Vehicle approaching speaker controller

·

Vehicle approaching speaker assembly

·

Harness or connector between vehicle approaching speaker controller and vehicle approaching speaker assembly



WIRING DIAGRAM

E282277E18
1.688,2.083 2.969,2.406 1.281,0.323 10 false Vehicle Approaching Speaker Controller 4.135,2.083 5.427,2.438 1.292,0.354 10 false Vehicle Approaching Speaker Assembly 1.677,1.917 2.052,2.094 0.375,0.177 10 false G85 4.135,1.927 4.406,2.104 0.271,0.177 10 false A73 2.688,1.125 3.094,1.323 0.406,0.198 10 false SP+ 2.688,1.542 2.958,1.719 0.271,0.177 10 false SP- 3.073,1.01 3.26,1.188 0.188,0.177 10 false 3 3.073,1.417 3.229,1.583 0.156,0.167 10 false 8 4.281,1.021 4.469,1.198 0.188,0.177 10 false 1 4.271,1.417 4.427,1.583 0.156,0.167 10 false 2 4.521,1.167 4.708,1.344 0.188,0.177 10 false + 4.521,1.521 4.708,1.698 0.188,0.177 10 false -

PROCEDURE

1.INSPECT VEHICLE APPROACHING SPEAKER ASSEMBLY
a.

Remove the vehicle approaching speaker assembly (See page Vehicle Exterior>VEHICLE PROXIMITY NOTIFICATION SYSTEM>VEHICLE APPROACHING SPEAKER>REMOVAL).


b.

Inspect the vehicle approaching speaker assembly (See page Vehicle Exterior>VEHICLE PROXIMITY NOTIFICATION SYSTEM>VEHICLE APPROACHING SPEAKER>INSPECTION).



OK

2.CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER CONTROLLER - VEHICLE APPROACHING SPEAKER ASSEMBLY)

NG

2.CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER CONTROLLER - VEHICLE APPROACHING SPEAKER ASSEMBLY)
a.

Disconnect the G85 vehicle approaching speaker controller connector.


b.

Disconnect the A73 vehicle approaching speaker assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G85-3 (SP+) - A73-1 (+) Always Below 1 Ω
G85-8 (SP-) - A73-2 (-) Always Below 1 Ω
G85-3 (SP+) or A73-1 (+) - Body ground Always 10 kΩ or higher
G85-8 (SP-) or A73-2 (-) - Body ground Always 10 kΩ or higher




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR