Home › Drivetrain › P510 (HYBRID TRANSMISSION / TRANSAXLE) › HYBRID TRANSAXLE SYSTEM › from 2017.06
RM2170E _52 Drivetrain _057013 P510 HYBRID TRANSMISSION / TRANSAXLE _0277987 HYBRID TRANSAXLE SYSTEM G

P510 HYBRID TRANSMISSION / TRANSAXLE  HYBRID TRANSAXLE SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT TRANSAXLE FLUID PRESSURE

a.

Remove the No. 1 engine under cover assembly (Integrated Cover Type).


b.

Remove the engine under cover LH (Separated Cover Type).


c.

Lift up the vehicle.


d.

Remove the fluid pump cover plug and O-ring.


e.
C209291E04
1.146,0.479 1.385,0.479 true 1.448,0.396 1.906,0.594 0.458,0.198 10 false SST

Install an oil pressure gauge with the adapter.


f.

Put the engine in inspection mode (See page General>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE).


g.

Measure the transaxle fluid pressure.

Reference:
Maintenance Mode Engine Idle Speed Hybrid Transaxle Fluid Temperature Hybrid Transaxle Fluid Pressure
900 to 1000 rpm 20 to 50°C (68 to 122°F) 4.0 kPa (0.04 kgf/cm2, 0.6 psi) or more


NOTICE:

Be sure to cancel inspection mode immediately after the transaxle fluid pressure check is completed.



h.
C209292

Install a new O-ring and fluid pump cover plug.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


i.

Install the No. 1 engine under cover assembly (Integrated Cover Type).


j.

Install the engine under cover LH (Separated Cover Type).