1.SECURE VEHICLE
Fully apply the parking brake and chock a wheel.
Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
33554C
2.REMOVE SHIFT LOCK RELEASE BUTTON COVER
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws to remove the shift lock release button cover from the position indicator housing.
Be careful not to damage the shift lock release button cover and the position indicator housing.
33504F
3.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
Move the shift lever to N.
Remove the shift lever knob sub-assembly.
4.REMOVE REAR CONSOLE BOX ASSEMBLY
33820B
5.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Disconnect the transmission control cable assembly from the shift lever assembly.
| *a | Rotate Approximately 180° |
| *b | Disconnect |
| *c | Nut |
Rotate the nut approximately 180° in the direction shown in the illustration, and while holding the nut, disconnect the transmission control cable assembly from the shift lever assembly.
Rotating the nut too much will damage the internal spring, and the transmission control cable assembly will not be reusable. Do not turn the nut too far.
6.REMOVE SHIFT LEVER ASSEMBLY
Disconnect the 2 connectors from the shift lever assembly.
Disengage the 2 clamps and separate the instrument panel wire from the shift lever assembly.
Remove the 4 bolts and shift lever assembly.