AUTOMATIC LIGHT CONTROL SYSTEM OPERATION CHECK (w/ Automatic Light Control)
Turn the power switch on (IG).
Turn the light control switch to the AUTO position.
Cover the automatic light control sensor.
Check that the taillights and low beam headlights come on.
Uncover the automatic light control sensor.
Check that the low beam headlights and taillights turn off.
LIGHT AUTO TURN-OFF SYSTEM OPERATION CHECK (w/ Light Auto Turn-off System (w/o Daytime Running Light))
Close the driver door.
Turn the power switch on (IG).
Turn the light control switch to the tail or head position.
Turn the power switch off.
Open the driver door.
Check that all of the lights go off immediately.
LIGHT AUTO TURN-OFF SYSTEM OPERATION CHECK (w/ Light Auto Turn-off System (w/ Daytime Running Light))
When the light control switch is in the tail or head position
Turn the power switch on (IG).
Turn the low beam headlights or high beam headlights on.
Turn the power switch off.
If the vehicle speed was not less than 10 km/h (6 mph) when the power switch was turned off, open the driver door.
Check that the low beam headlights and high beam headlights turn off immediately.
The taillights, clearance lights and license plate lights remain on.
When the light control switch is in the AUTO position
Turn the power switch on (IG).
Turn the taillights, low beam headlights or high beam headlights on.
Turn the power switch off.
If the vehicle speed was not less than 10 km/h (6 mph) when the power switch was turned off, open the driver door.
Check that all of the lights turn off immediately.
DAYTIME RUNNING LIGHT SYSTEM OPERATION CHECK (w/ Daytime Running Light)
Turn the power switch on (READY).
Turn the light control switch to the AUTO position (make sure the taillights are not turned on by the automatic light control system).
Release the parking brake.
Check that the daytime running lights come on.