Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY (for LED Headlight) › from 2017.06
RM2170E _59 Vehicle Exterior _057049 LIGHTING (EXT) _0278187 HEADLIGHT ASSEMBLY(for LED Headlight) A

LIGHTING (EXT)  HEADLIGHT ASSEMBLY(for LED Headlight)  REPAIR  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.

·

If the installation area of the headlight assembly is damaged, use the supply retainer for low-cost repair.

·

Ensure that the headlight assembly is not damaged.



PROCEDURE

Hide 81194 1.INSTALL UPPER HEADLIGHT PROTECTOR RETAINER

a.
E372967

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the upper headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E372968

Install the upper headlight protector retainer with the 2 screws.


Hide 81196A 2.INSTALL LOWER HEADLIGHT PROTECTOR RETAINER

a.
E372969

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the lower headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E372970

Install the lower headlight protector retainer with the 2 screws.


Hide 81198 3.INSTALL LOWER HEADLIGHT BRACKET

a.
E372971

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the lower headlight bracket against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E372972

Install the lower headlight bracket with the 2 screws.