Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY › from 2017.06
RM2170E _59 Vehicle Exterior _057049 LIGHTING (EXT) _0278190 REAR COMBINATION LIGHT ASSEMBLY A

LIGHTING (EXT)  REAR COMBINATION LIGHT ASSEMBLY  DISASSEMBLY  


PROCEDURE

Hide 81550L 1.REMOVE REAR TURN SIGNAL LIGHT BULB

a.
E372187

Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb as shown in the illustration to disconnect them as a unit.


b.

Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.


Hide 81550N 2.REMOVE BACK-UP LIGHT BULB

a.
E372189

Disengage the guide and disconnect the rear combination light socket and wire sub-assembly.


b.

Turn the rear combination light socket and wire sub-assembly with the back-up light bulb as shown in the illustration to disconnect them as a unit.


c.

Remove the back-up light bulb from the rear combination light socket and wire sub-assembly.


Hide 81536A 3.REMOVE REAR COMBINATION LIGHT LED (for STOP LIGHT)

a.
E372191

Remove the screw.


b.

Turn the rear combination light LED as shown in the illustration to remove it.


c.

Disconnect the connector.


Hide 81536A 4.REMOVE REAR COMBINATION LIGHT LED (for TAIL LIGHT)

a.
E372193

Disengage the guide and disconnect the rear combination light socket and wire sub-assembly.


b.

Remove the screw.


c.

Turn the rear combination light LED as shown in the illustration to remove it.


d.

Disconnect the connector.


Hide 81565 5.REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY