71075B
1.INSTALL BENCH TYPE REAR SEAT CUSHION COVER
Temporarily install the bench type rear seat cushion cover to the bench type rear seat cushion pad.
Using hog ring pliers, install the bench type rear seat cushion cover to the bench type rear seat cushion pad with 16 new hog rings.
Be careful not to damage the cover.
When installing the hog rings, take care to minimize wrinkles as much as possible.
for Type A:
Using hog ring pliers, install 37 new hog rings.
Be careful not to damage the cover.
When installing the hog rings, take care to minimize wrinkles as much as possible.
for Type B:
Using hog ring pliers, install 39 new hog rings.
Be careful not to damage the cover.
When installing the hog rings, take care to minimize wrinkles as much as possible.
72640A
2.INSTALL REAR SEATBACK LOCK ASSEMBLY LH
Install the rear seatback lock assembly LH to the rear seatback frame sub-assembly LH with the 2 bolts.
71078S
3.INSTALL SEPARATE TYPE REAR SEATBACK COVER (for LH Side)
Temporarily install the separate type rear seatback cover to the separate type rear seatback pad.
Using hog ring pliers, install the separate type rear seatback cover to the separate type rear seatback pad with 2 new hog rings.
Be careful not to damage the cover.
When installing the hog rings, take care to minimize wrinkles as much as possible.
4.INSTALL SEPARATE TYPE REAR SEATBACK COVER WITH PAD (for LH Side)
Temporarily install the separate type rear seatback cover with pad to the rear seatback frame sub-assembly LH.
Engage the 4 claws to install the 2 rear seat headrest supports to the rear seatback frame sub-assembly LH.
Engage the 4 claws to install the 2 rear center seat headrest supports to the rear seatback frame sub-assembly LH.
Engage the hook.
Close the 2 fasteners as shown in the illustration.
Install the 2 clips.
Install the 3 clips.
72646A
5.INSTALL REAR SEATBACK STOP BUTTON GROMMET (for LH Side)
Engage the 2 claws to install the rear seatback stop button grommet to the separate type rear seatback cover with pad.
72661C
6.INSTALL REAR SEATBACK LOCK RELEASE BUTTON (for LH Side)
Turn the rear seatback lock release button in the direction indicated by arrow to install it.
72630C
7.INSTALL REAR SEATBACK LOCK ASSEMBLY RH
Install the rear seatback lock assembly RH to the rear seatback frame sub-assembly RH.
71077S
8.INSTALL SEPARATE TYPE REAR SEATBACK COVER (for RH Side)
Temporarily install the separate type rear seatback cover to the separate type rear seatback pad.
Using hog ring pliers, install the separate type rear seatback cover to the separate type rear seatback pad with 2 new hog rings.
Be careful not to damage the cover.
When installing the hog rings, take care to minimize wrinkles as much as possible.
9.INSTALL SEPARATE TYPE REAR SEATBACK COVER WITH PAD (for RH Side)
Temporarily install the separate type rear seatback cover with pad to the rear seatback frame sub-assembly RH.
Engage the 4 claws to install the 2 rear seat headrest supports to the rear seatback frame sub-assembly RH.
Engage the hook.
Close the 2 fasteners as shown in the illustration.
Install the 2 clips.
Install the 2 clips.
72646A
10.INSTALL REAR SEATBACK STOP BUTTON GROMMET (for RH Side)
Use the same procedure as for the LH side.
72661C
11.INSTALL REAR SEATBACK LOCK RELEASE BUTTON (for RH Side)
Use the same procedure as for the LH side.