Home › Engine / Hybrid System › 1NZ-FXE (COOLING) › TEMPERATURE SWITCH › from 2017.06
RM2170E _51 Engine / Hybrid System _057009 1NZ-FXE COOLING _0320240 TEMPERATURE SWITCH G

1NZ-FXE COOLING  TEMPERATURE SWITCH  INSPECTION  


PROCEDURE

Hide 89429E 1.INSPECT ENGINE COOLANT TEMPERATURE SENSOR

a.
A250800

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Condition Specified Condition
Approximately 20°C (68°F) 2.32 to 2.59 kΩ
Approximately 80°C (176°F) 0.310 to 0.326 kΩ


NOTICE:

When checking the engine coolant temperature sensor in water, keep the terminals dry. After the check, dry the engine coolant temperature sensor.


If the resistance is not as specified, replace the engine coolant temperature sensor.