INITIALIZE POWER WINDOW CONTROL SYSTEM (for Driver Door)
When the door window regulator sub-assembly, power window regulator motor assembly (for driver door), door glass or door glass run is reinstalled or replaced, the power window control system must be initialized. Functions such as the auto up and down function, jam protection function, catch protection function and key-off operation function will not operate if initialization is not performed.
When the power window regulator motor assembly (for driver door) is replaced, DTC B2313 is stored. Clear the DTC after performing initialization.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DTC CHECK / CLEAR
When performing initialization, do not perform any other procedures.
If initialization cannot be completed properly, the LIN communication system may be malfunctioning.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Make sure to park the vehicle and turn off all electrical systems before performing initialization. Initialization will be canceled if the vehicle is driven during initialization.
Make sure not to hit, strike or vibrate the door glass during initialization because the vehicle is learning the sliding resistance of the door glass.
Make sure not to turn the power switch off during initialization.
If the auxiliary battery has been replaced, it is not necessary to initialize the power window regulator motor assemblies.
Perform initialization according to the table below.
| Condition of Power Window | Proceed to |
|---|---|
| The power window regulator motor assembly (for driver door) has been replaced with a new one. | Procedure A |
·
Power window regulator motor assembly (for driver door) has been removed/installed or a door glass and/or door glass run, etc. have been removed/installed or replaced with new ones. ·
Power window cannot be fully opened via a down operation (door glass remains visible). ·
Power window cannot be fully closed (erroneously operates in reverse) after initialization. ·
Power window cannot be fully opened (erroneously stops) after initialization. ·
Instructions to perform initialization appear in a troubleshooting procedure.
|
Procedure B |
| Power window unexpectedly operates in reverse or stops due to a change in the sliding resistance after a fitting adjustment is made. | Procedure C |
Procedure A
Perform window position initialization (fully closed, fully open) and sliding resistance learning.
*: Even if the door glass is in the fully open position before performing step 3, push down and hold the switch for 1 second or more.
Procedure B
Reset the power window position, perform window position initialization (fully closed, fully opened) and sliding resistance learning.
*1: After performing step 7, release the switch, and then perform an auto down operation.
*2: After completing initialization, check that the power window can be fully closed using an auto up operation.
If initialization cannot be completed properly, the LIN communication system may be malfunctioning.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Procedure C
Perform sliding resistance learning.
If the jam protection function or catch protection function continues to operate even after performing steps 4, 5 and 6, perform the procedure again from step 3.