CUSTOMIZE POWER WINDOW CONTROL SYSTEM
The following items can be customized.
When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.
Customizing with the GTS
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Customize Setting / Power Window.
Select the setting by referring to the table below.
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| D Window Auto Up | Function to enable or disable the auto up function for the driver door power window using the power window regulator master switch assembly | ON | 0:OFF,1:ON | Power window regulator motor assembly (for Driver Door) |
| D Window Auto Down | Function to enable or disable the auto down function for the driver door power window using the power window regulator master switch assembly | ON | 0:OFF,1:ON | Power window regulator motor assembly (for Driver Door) |